See page 38 for information about setting the configure mode. Closing the Handle 5. Intel assumes no responsibility for any errors that may appear in this document. That being said the only other popular key used that I know of is F2 try that during drive recognition, and that might work for you. Installing and Replacing Desktop Board Components Installing the Desktop Board Refer to your chassis manual for instructions on installing the desktop board. The figure legend below lists the colors used. If no memory was added, there may be a problem with the system.

Uploader: Shajar
Date Added: 23 May 2005
File Size: 63.90 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 65635
Price: Free* [*Free Regsitration Required]

Close the handle completely see Figure Clearing The Passwords D815eew and Replacing Desktop Board Components Clearing the Passwords This procedure assumes that the desktop board is installed in the computer and the configuration jumper block is set to normal mode.

Intel D815EEA, Socket 370 (BOXD815EEAA) Motherboard

The BIOS also issues a beep code one long tone followed by two short tones during POST if the video configuration fails a faulty video card or no card installed or if an external ROM module does not properly checksum to zero.

Installing and Replacing Desktop Board Components 4. Intel server board technical product specification pages. Table of Contents Add to my manuals Add.


By pressing ‘print’ button you will print only current page. Make the changes, shutdown, change the jumper back, and then the system will boot with the new settings.

Intel Desktop Board D815EEA – motherboard – ATX – Socket 370 – i815E Series

This submenu becomes available when User Defined is selected under Extended Configuration. Processors A Celeron PPGA and processor For the latest information on motherboarr support for the board, refer to the Intel desktop board web site at: Newer cards have a retention notch as shown in Figure 3. Prevent Power Supply Overload Appropriate protection is provided by a maximum 8 A current limiting circuit, or a maximum 5 A fuse, or positive temperature coefficient PTC resistor.

Calculate the standby current requirements using the steps described below.

Revision History Disclaimer Intel Corporation Intel makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Also, check your manual. That being said the only other popular key used that I know of is F2 try that during drive motherboaed, and that might work for you.

When using notched cards, install the AGP card retention mechanism before installing the card.

Moving the jumper with the power on may result in unreliable computer operation. The figure legend below lists the colors used.


To access this menu, select Maintenance on the menu bar at the top of the screen. Using the Motnerboard Program Table d815ea Results 1 to 5 of 5 Thread: Allowing the card to slide forward or backward even a little during installation can damage the pins of the AGP socket.

Some Intel boards have a jumper on the board that will start the bios when you boot. The desktop board is secured to the chassis by seven screws.

Downloads for IntelĀ® Desktop Board DEEA

Technical Reference Midboard Connectors Figure 22 shows the location of the midboard connectors. EXE file and type: All times are GMT Don’t have an account?

Page 24 – Installing and Removing the Motgerboard Me Creating A Bios Upgrade Diskette 8.

B Regulatory and Integration Information This appendix contains: I do not have multiple personality disorder Figure 10 shows the locations of the mounting screw holes. Page of 82 Go. If used, mechanically precludes the use of PCI slot 5.